Every Steroid has a different melting point and some steroids are even totally liquid at room temperature like Boldenone Undeclyenate (EQ). This means that it is possible to test the purity of your Steroid powders by heating them to their expected melting point. If the product is pure it will entirely melt at this temperature and over a small spread.
Steroid Melting Point Test Process
Because we are testing something specific, it is important to be specific in your procedure. So the first step is acquiring a means to accurately control the temperature. Ideally you are heating the product by using an electronic Hot-Plate. Oil/water baths and thermometers are also a good option. Please note ovens do not provide any kind of meaningful result because the temperature of an oven is constantly fluctuating, and we intend to see exactly how the compound reacts around its melting point.
All you need to complete this test is the following table, a Hot-Plate and the compound in testing
1.) Place some aluminium foil on the surface of the Hot-Plate / oil / water and ensure it is in contact across the entire surface. If this can not be achieved use a cooking pan on top of the electronic Hot-Plate.
2.) Place a small amount of the Compound on the Foil, only a tiny amount is required, big enough that that you can judge where it begins to melt but not so much that it will melt unevenly.
3.) Set the Hot-Plate/water/oil bath to just below the correct temperature range based on the confirmed melting point of the compound.
4.) Raise the temperature by 1c every 30s, all of the compound must dissolve within 1-3 Celsius and at/within the confirmed melting point range of the compound – provided this occurs you are looking at 98-99%+ purity compound.
Convert Celsius to Fahrenheit:
1) Determine the temperature in Celsius
2) Using your calculator, multiply the temperature times 1.8
3) Add 32 to the result
4) Your final answer is the temperature in Fahrenheit